Gasoline and Diesel engine oil - Euro 4, 5 and 6 5W30
100% Synthetic
100% Synthetic high performance lubricant specially developed for Gasoline and Diesel engines meeting Euro 4, 5 or 6 emission standards, requiring an oil both high HTHS (>3.5 mPa.s) and "Mid SAPS", reduced content of Sulfated Ash (≤ 0.8%), Phosphorus (0.07% ≤ x ≤ 0.09%) and Sulfur (≤ 0.3%). Compatible with catalytic converters (CAT) and DPF - Diesel Particulate Filter. Especially recommended for vehicles of the BMW, MERCEDES, PORSCHE and VAG (VW, Audi, Seat, Skoda) groups of the latest generation.
Also suitable for gasoline and diesel engines requiring ACEA C3 lubricant.
Always consult the vehicle's service manual before use.
ACEA C3 STANDARDS
APPROVALS BMW LL-04
MERCEDES-BENZ MB-Approval 229.51
PORSCHE C30
VW 504 00 507 00
Can of 5 liters
MOTUL Engine Flush 300ml engine cleaner
MOTUL Engine Flush pre-oil change cleaner for petrol and/or diesel engines
Recommendations for use
MOTUL Engine Flush can be used in all types of 4-stroke engines, petrol and/or diesel, naturally aspirated or turbocharged, with or without after-treatment systems, using any type of fuel.
It effectively cleans deposits and sludge from the engine. The micro-particles thus loosened are then evacuated in the engine oil during the oil change.
Ensures high-level lubrication during the cleaning process.
Performance
MOTUL Engine Flush added to the engine oil before the oil change allows:
- reduced wear
- lower oil and fuel consumption
- increased compression across all cylinders
- reduced exhaust pollutant emissions
- removes deposits, varnish and other combustion residues from risk areas such as hydraulic tappets or piston grooves and rings
- fully benefits from all the qualities of the new oil that will follow the change
- increases the service life of the after-treatment system, catalytic converter and particulate filter (FAP and GPF)
Recommendations
- Before each engine oil change, add a dose of MOTUL Engine Flush to the used oil in the engine while it is warm.
- Leave the engine idling for 15 minutes.
- Then drain the engine oil and change the oil filter.
- One dose is sufficient for an engine oil capacity of up to 5 litres. For larger capacities, add 60 ml of Engine Flush per additional litre of oil (above 5 litres).
- For very dirty engines, do not increase the dosage but carry out two successive treatments.
300 ml bottle
Motul 8100 X-clean+ Engine Oil Change Kit with Free Engine Cleaner
16 other products in the same category:
- 3x loyalty points
- 3x loyalty points
- 3x loyalty points
- 3x loyalty points