Inoxcar Cupra Ateca 2.0 TSI 190 ch 4Drive (2023-2026) Cat-Back, 4x90 mm ceramic black outlets

The Inoxcar Cat-Back for the Cupra Ateca 2.0 TSI 190 ch 4Drive (2023–2026) combines a mid-pipe without a muffler with a stainless steel rear muffler. This configuration delivers a more pronounced and sportier sound than the stock exhaust.

The four 90 mm round Racing Black Ceramic outlets—two on the right and two on the left—feature a black ceramic finish. They mirror the outlet layout of the 300 ch version.

Mounting requires replacing the rear diffuser with the original model from the Cupra Ateca 2.0 TFSI 300 ch, as well as cutting into the stock exhaust line.

Technical Specifications

• Brand: Inoxcar
• Manufacturer Part Number: CATBACK.ATECA.01.90CBLACK
• Type: Cat-Back
• Components: Intermediate pipe without muffler and rear muffler
• Material: stainless steel
• Pipe diameter: 70 mm
• Outside diameter of the inlet fitting: 65 mm
• Outlets: four 90-mm round tips, two on the right and two on the left
• Outlet finish: Racing Black Ceramic
• With valve: no
• ECE approval: Not approved

Compatible vehicle

• Cupra Ateca 2.0 TSI 190 ch 4Drive (2023–2026), with the stock rear diffuser from the Cupra Ateca 2.0 TFSI 300 ch model.

Mounting Requirements

This system is designed for the rear diffuser of the Ateca 300 ch. Check this equipment before installation. Installation requires cutting the stock exhaust: position the components and check the alignment of the four outlets before performing the final tightening.

This Cat-Back system is not ECE-approved for road use.