ACL Race Series Connecting Rod Bushes - Opel and General Motors C20LET, C20XE, and Z20LET - STD - 4B2322H-STD
The ACL Race Series 4B2322H-STD trimetal connecting rod bushes are designed for Opel, General Motors, and Holden C20LET, C20XE, and Z20LET engines. Installed in the connecting rod top ends, they serve as the interface between the connecting rod and the crankpin. Their selection determines the operating clearance and oiling of the lower engine assembly. Part number 4B2322H-STD corresponds to the standard (STD) size.
ACL Race Series trimetal technology consists of a steel base and a copper-lead-tin layer protected by a nickel barrier. The assembly is completed by a surface layer designed to enhance bearing performance under load and resistance to seizure.
The H version with STD dimensions is intended for mounting while maintaining the nominal dimensions of the crankshaft journals. To determine the actual oil clearance, measure the bearings once they are installed and the caps are tightened to the specified torque.
Technical Specifications
- Type: Connecting rod bush
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer Part Number: 4B2322H-STD
- Dimension: standard dimension (STD)
- Version: H
- Main engines: C20LET, C20XE, and Z20LET
- Manufacturers: Opel | General Motors | Holden
- Rod journal diameter (nominal dimension): 48.971 to 48.987 mm
- Connecting rod top end bore: 52 to 52.012 mm
- Maximum thickness at the top: 1.498 mm
- Maximum width: 19.3 mm
Engine models compatible with ACL 4B2322H-STD bearings
This part number applies specifically to the following engine models in the described family: C20LET | C20XE | Z20LET | 16N | 16SH | 16D | 16DA | 18E | 18N | 18NV | 18S | 18SE | 18SEH | 18SV | C18NE | C18NT | C18NV | C18NZ | C18XE | C18XEL. The list of engine codes and applications must be verified against the exact mounting before ordering.
Mounting Recommendations
Mounting Recommendation: Check the surface condition of the crankshaft, measure the diameters of the crankpins, and measure the oil clearance with the half-bearings installed. Follow the engine tightening procedure.
ACL Race Series develops engine bearings for competition and tuning, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical resistance and control of operating clearances.
-
Thickness in mm1,50
-
Width in mm19,30
-
Engine codeC20LET - 2.0L 16V
C20XE - 2.0L 16V
Z20LET - 2.0L 16V -
Make (Engine)General Motors
Holden
Opel -
Rod Journal Diameter in mm48,97
48,99 -
Max. connecting rod bore in mm52,01
-
Min. connecting rod bore in mm52,00