ACL Race Series Connecting Rod Bushes - Opel and General Motors 16N, 16SH, and 16D - 0.025 mm - 4B2322H-.025

ACL
Reference: ACL-4B2322H-0025
Supplier Ref.: 4B2322H-.025

Price: CHF 65.30 Tax included
Supplier stock Shipped between 2026-11-27 and 2026-12-02 from our warehouse
Unavailable in store (Promasens)
Earn 65 loyalty points

ACL Race Series 4B2322H-.025 trimetal connecting rod bushes are designed for Opel, General Motors, and Holden 16N, 16SH, and 16D engines. In the lower engine, they allow the connecting rods to rotate around the crankpins while supporting the loads transmitted by the pistons. Part number 4B2322H-.025 corresponds to a thickness of 0.025 mm.

Developed to withstand the stresses of engine tuning, ACL Race Series trimetal bearings combine a steel backing, a copper-lead-tin alloy, a nickel barrier, and an anti-friction layer. Their radial runout helps maintain the oil film when the bearing seats undergo deformation during operation.

This 0.025 mm version allows you to select bearings that match the actual condition of the crankshaft journals. The selection should be based on crankshaft measurements, not solely on the engine’s tuning level.


Technical Specifications

  • Type: connecting rod bushes
  • Manufacturer: ACL
  • Range: ACL Race Series
  • Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
  • ACL Material: F781 (Race Series connecting rod bushes)
  • Manufacturer part number: 4B2322H-.025
  • Thickness: 0.025 mm
  • Version: H
  • Main engines: 16N, 16SH, and 16D
  • Manufacturers: Opel | General Motors | Holden

Engine types compatible with ACL 4B2322H-.025 bearings

This part number applies specifically to the following engine models in the described family: 16N | 16SH | 16D | 16DA | 18E | 18N | 18NV | 18S | 18SE | 18SEH | 18SV | C18NE | C18NT | C18NV | C18NZ | C18XE | C18XEL | E18NV | E18NVR | S18NV. The list of engine codes and applications must be verified against the exact mounting configuration before ordering.

Mounting Recommendations

Mounting Recommendation: Before assembly, verify the geometry of the connecting rod top ends, the actual dimension of the crankshaft journals, and the final oil clearance. Apply the torque values and follow the tightening sequence specified for the engine. A replacement-sized bearing should only be installed if the corresponding machining has been performed.

ACL Race Series develops engine bearings for competition and tuning applications, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical strength and precise control of operating clearances.

  • Thickness in mm
    1,5
  • Width in mm
    19,30
  • Engine code
    C20LET - 2.0L 16V
    C20XE - 2.0L 16V
    Z20LET - 2.0L 16V
  • Make (Engine)
    General Motors
    Holden
    Opel
  • Rod Journal Diameter in mm
    48,95
    48,96
  • Max. connecting rod bore in mm
    52,01
  • Min. connecting rod bore in mm
    52,00

16 other products in the same category: