Hylomar Exhaust Repair Putty is a water based, heat curing product. It has been specifically designed for use in the repair of exhaust systems within the automotive industry. The exhaust putty formulation will withstand both pressure and temperatures typically found in vehicle exhaust systems. When heated the product cures to form a gas tight seal.
Instructions for use :
Ensure the surfaces to be joined are clean and free of loose rust, dirt and grease. Abrade the surface with medium emery paper or wire brush. Moisten the area with water and apply the putty with a knife. Force the putty into the repair to give added strength. Soften putty with water if necessary.
Replace lid firmly after use. Run the engine at low speed until warm, this will ensure rapid hardening of the repair putty and will set to form a gas tight seal.
CAUTION: Avoid running engines in confined spaces.
Service temperature : up to 1000°C (1832°F)
Capacity : 250g
Instructions for use :
Ensure the surfaces to be joined are clean and free of loose rust, dirt and grease. Abrade the surface with medium emery paper or wire brush. Moisten the area with water and apply the putty with a knife. Force the putty into the repair to give added strength. Soften putty with water if necessary.
Replace lid firmly after use. Run the engine at low speed until warm, this will ensure rapid hardening of the repair putty and will set to form a gas tight seal.
CAUTION: Avoid running engines in confined spaces.
Service temperature : up to 1000°C (1832°F)
Capacity : 250g
-
Capacity in g250
16 other products in the same category:
ECOTEC
ECO 5 Detox ECOTEC multifunction diesel engine cleaner 1L
CHF 41.70
-5%
CHF 39.62
(tax incl.)
In stock
LOCTITE
Loctite 3020 adhesive spray for holding pre-cut joints 400ml
CHF 27.20
-15%
CHF 23.12
(tax incl.)
In stock
SILKOLENE
Silkolene Gasoline Additive | PRO BOOST Octane Booster 1 L
CHF 37.00
-15%
CHF 31.45
(tax incl.)
In stock
LOCTITE
Loctite masterjoint high temperature 510 25ml syringe
CHF 24.00
-15%
CHF 20.40
(tax incl.)
In stock
