ACL Race Series Connecting Rod Bushes - Toyota 1GR-FE and 1GR - STD - 6B8262HX-STD
The ACL Race Series 6B8262HX-STD trimetal connecting rod bushes are designed for Toyota 1GR-FE and 1GR engines. In the lower engine, they allow the connecting rods to rotate around the crankpins while supporting the loads transmitted by the pistons. Part number 6B8262HX-STD corresponds to the standard size (STD).
Developed to withstand the stresses of engine tuning, ACL Race Series trimetal connecting rod bearings combine a steel backing, a copper-lead-tin alloy, a nickel barrier, and an anti-friction layer. Their radial runout helps maintain the oil film when the bearing seats undergo deformation during operation.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening the connecting rod caps.
Technical Specifications
- Type: Connecting rod bush
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer part number: 6B8262HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: 1GR-FE and 1GR
- Manufacturers: Toyota
- Rod journal diameter (nominal dimension): 55.992 to 56 mm
- Connecting rod top end bore: 59 to 59.025 mm
- Maximum thickness at the top: 1.479 mm
- Maximum width: 16 mm
Engine models compatible with ACL 6B8262HX-STD bearings
The engine models listed for this set include: 1GR-FE | 1GR.
Mounting Recommendations
Mounting recommendation: Before assembly, check the geometry of the connecting rod top ends, the actual dimension of the crankshaft journals, and the final oil clearance. Apply the torque values and follow the tightening sequence specified for the engine.
ACL Race Series develops engine bearings for competition and performance applications, featuring precision manufacturing, controlled shell thickness, and a trimetal design optimized for mechanical strength and precise control of operating clearances.
-
Thickness in mm1,48
-
Width in mm16,00
-
Make (Engine)Toyota
-
Rod Journal Diameter in mm55,99
56,00 -
Max. connecting rod bore in mm59,03
-
Min. connecting rod bore in mm59,00