ACL Race Series Connecting Rod Bushes - Toyota 2AZ, 1AZ-FE, and 2AZ-FE - STD - 4B8411HX-STD

ACL
Reference: ACL-4B8411HX-STD
Supplier Ref.: 4B8411HX-STD

Price: CHF 53.90 Tax included
Available to order Within 20 days on average.
Unavailable in store (Promasens)
Earn 53 loyalty points

ACL Race Series 4B8411HX-STD connecting rod bushes with a trimetal construction are designed for Toyota 2AZ, 1AZ-FE, and 2AZ-FE engines. Installed in the connecting rod top ends, they serve as the interface between the connecting rod and the crankpin. Their selection determines the operating clearance and oiling of the lower engine assembly. Part number 4B8411HX-STD corresponds to the standard (STD) size.

ACL Race Series trimetal technology consists of a steel base and a copper-lead-tin layer protected by a nickel barrier. The assembly is completed by a surface layer designed to enhance bearing performance under load and resistance to seizure.

The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening the connecting rod caps.


Technical Specifications

  • Type: connecting rod bushes
  • Manufacturer: ACL
  • Range: ACL Race Series
  • Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
  • ACL Material: F781 (Race Series connecting rod bushes)
  • Manufacturer Part Number: 4B8411HX-STD
  • Dimension: standard dimension (STD)
  • Version: HX, increased oil clearance compared to the corresponding H version
  • Main engines: 2AZ, 1AZ-FE, and 2AZ-FE
  • Manufacturers: Toyota
  • Rod journal diameter (nominal dimension): 47.99 to 48 mm
  • Connecting rod top end bore: 51 to 51.02 mm
  • Maximum thickness at the top: 1.477 mm
  • Maximum width: 15.6 mm

Engine models compatible with ACL 4B8411HX-STD bearings

The engine models listed for this set include: 2AZ | 1AZ-FE | 2AZ-FE | 2AZ-FXE | 1AZ.

Mounting Recommendations

Mounting recommendation: Check the surface condition of the crankshaft, measure the diameters of the crankpins, and measure the oil clearance with the half-bearings installed. Follow the engine tightening procedure.

ACL Race Series develops engine bearings for competition and tuning, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical strength and precise control of operating clearances.

  • Thickness in mm
    1,48
  • Width in mm
    15,60
  • Engine code
    2AZ - 2.4L 16V
  • Make (Engine)
    Toyota
  • Rod Journal Diameter in mm
    47,99
    48,00
  • Max. connecting rod bore in mm
    51,02
  • Min. connecting rod bore in mm
    51,00

16 other products in the same category: