ACL Race Series Connecting Rod Bushes - Toyota 2GR-FE and 2GR - STD - 6B8466HX-STD
ACL Race Series 6B8466HX-STD connecting rod bushes with a trimetal construction are designed for Toyota 2GR-FE and 2GR engines. Installed in the connecting rod top ends, they serve as the interface between the connecting rod and the crankpin. Their selection determines the operating clearance and oiling of the lower engine. Part number 6B8466HX-STD corresponds to the standard (STD) size.
ACL Race Series trimetal technology consists of a steel base and a copper-lead-tin layer protected by a nickel barrier. The assembly is completed by a surface layer designed to enhance bearing performance under load and resistance to seizure.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening the connecting rod caps.
Technical Specifications
- Type: connecting rod bushes
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer Part Number: 6B8466HX-STD
- Specification: standard specification (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: 2GR-FE and 2GR
- Manufacturers: Toyota
- Rod journal diameter (nominal dimension): 52.98 to 53 mm
- Connecting rod top end bore: 56 to 56.02 mm
- Maximum thickness at the top: 1.477 mm
- Maximum width: 15 mm
Engine models compatible with ACL 6B8466HX-STD bearings
The engine models listed for this set include: 2GR-FE | 2GR.
Mounting Recommendations
Mounting recommendation: Check the surface condition of the crankshaft, measure the diameters of the crankpins, and measure the oil clearance with the half-bearings installed. Follow the engine tightening procedure.
ACL Race Series develops engine bearings for competition and performance applications, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical resistance and precise control of operating clearances.
-
Thickness in mm1,48
-
Width in mm15,00
-
Make (Engine)Toyota
-
Rod Journal Diameter in mm52,98
53,00 -
Max. connecting rod bore in mm56,02
-
Min. connecting rod bore in mm56,00