ACL Race Series Connecting Rod Bushes - Honda and Acura J32 and J35 - STD - 6B1995HX-STD
ACL Race Series 6B1995HX-STD trimetal connecting rod bushes are designed for Honda and Acura J32 and J35 engines. Installed in the connecting rod top ends, they serve as the interface between the connecting rod and the crankpin. Their selection determines the operating clearance and oiling of the lower engine. Part number 6B1995HX-STD corresponds to the standard (STD) size.
ACL Race Series trimetal technology consists of a steel bracket and a copper-lead-tin layer protected by a nickel barrier. The assembly is completed by a surface layer designed to enhance bearing performance under load and resistance to seizure.
The HX suffix identifies a version designed to adjust the oil clearance. For the HX version, ACL specifies approximately 0.025 mm of additional clearance compared to an H version of the same size, on a crankshaft of corresponding sizes. The mounting must be checked after tightening of the connecting rod caps.
Technical Specifications
- Type: connecting rod bush
- Manufacturer: ACL
- Range: ACL Race Series
- Design: trimetal, steel backing, and copper-lead-tin anti-friction plies
- ACL Material: F781 (Race Series connecting rod bushes)
- Manufacturer part number: 6B1995HX-STD
- Dimension: standard dimension (STD)
- Version: HX, increased oil clearance compared to the corresponding H version
- Main engines: J32 and J35
- Manufacturers: Honda | Acura
- Rod journal diameter (nominal dimension): 54.976 to 55.001 mm
- Connecting rod top end bore: 57.998 to 58.016 mm
- Maximum thickness at the top: 1.489 mm
- Maximum width: 14.5 mm
Engine models compatible with ACL 6B1995HX-STD bearings
The engine models listed for this set include: J32A | J35A | J32 | J35.
Mounting Recommendations
Mounting recommendation: Check the surface condition of the crankshaft, measure the diameters of the crankpins, and measure the oil clearance with the half-bearings installed. Follow the engine tightening procedure.
ACL Race Series develops engine bearings for competition and tuning, featuring precision manufacturing, shell thickness control, and a trimetal design focused on mechanical strength and precise control of operating clearances.
-
Thickness in mm1,49
-
Width in mm14,50
-
Engine codeJ32A - 3.2L 24V
J35A - 3.5L 24V -
Make (Engine)Acura
Honda -
Rod Journal Diameter in mm54,98
55,00 -
Max. connecting rod bore in mm58,02
-
Min. connecting rod bore in mm58,00